1 Scope
This European Standard specifies the required properties of the piping system and
its components made from glass-reinforced thermosetting plastics (GRP) based on unsaturated
polyester resin (UP) intended to be used for water supply (drinking or raw) with or
without pressure. In a pipework system, pipes and fittings of different nominal pressure and stiffness ratings may be used together.
It is the responsibility of the purchaser or specifier to make the appropriate selections
taking into account their particular requirements and any relevant national regulations
and installation practices or codes.
This European Standard is applicable to GRP-UP, with flexible or rigid joints (see 3.33 and 3.34), primarily intended for use in buried installations.
NOTE Piping systems conforming to this European Standard can also be used for non-buried
applications provided that the influence of the environment, e.g. from UV-radiation,
and the supports are considered in the design of the pipes, fittings and joints.
It is applicable to pipes, fittings and their joints of nominal sizes from DN 100 to DN 4000, which are intended to be used for the conveyance of water
at temperatures up to 50 °C, with or without pressure.
This European Standard covers a range of nominal sizes , nominal stiffnesses and nominal pressures . This European Standard is applicable to fittings made using any of the following
techniques:
Open preview (PDF)Plastics piping systems for water supply with or without pressure. Glass-reinforced thermosetting plastics (GRP) based on unsaturated polyester resin (UP)