Plastics. Determination of temperature of deflection under load - Plastics and ebonite
Open preview (PDF)Plastics. Determination of temperature of deflection under load - Plastics and ebonitePlastics. Determination of temperature of deflection under load - Plastics and ebonite
This site uses cookies and visit counters for operation and statistics. Privacy policy
1 Scope This part of ISO 75 specifies three methods, using different values of constant flexural stress, which can be used for the determination of the temperature of deflection under load of plastics (including filled plastics and fibre-reinforced plastics in which the fibre length, prior to processing, is up to 7,5 mm) and ebonite:
— method A, using a flexural stress of 1,80 MPa;
— method B, using a flexural stress of 0,45 MPa;
— method C, using a flexural stress of 8,00 MPa.
The standard deflection, Δ s , used to determine the temperature of deflection under load corresponds to a flexural-strain increase, Δ ε f , defined in this part of ISO 75. The initial flexural strain due to the loading of the specimen at room temperature is neither specified nor measured in this part of ISO 75. The ratio of this flexural-strain increase to the initial flexural strain depends on the modulus of elasticity, at room temperature, of the material under test. This method is, therefore, only suitable for comparing the temperatures of deflection of materials with similar room-temperature elastic properties.
NOTE 1 The methods give better reproducibility with amorphous plastics than with semi-crystalline ones. With some materials, it can be necessary to anneal the test specimens to obtain reliable results. Annealing procedures, if used, generall...
Mentioned in the description and other BS standards
