BS EN ISO 9445-2:2010 Continuously cold-rolled stainless steel. Tolerances on dimensions and form. Wide strip and plate/sheet
BS EN ISO 9445 consists of the following parts, under the general title Continuously cold-rolled stainless steel. Tolerances on dimensions and form:
Part 1: Narrow strip and cut lengths
Part 2: Wide strip and plate/sheet
BS EN ISO 9445 Part 2 specifies the tolerances on dimensions and form for continuously cold-rolled stainless steel wide strip and plate/sheet, in thicknesses from 0,30 mm to 8,0 mm and in rolling widths from 600 mm to 2 100 mm.
It also applies to slit cold-rolled wide strip in widths less than 600 mm manufactured from wide strip by longitudinal slitting and to cut lengths manufactured from such strip.
Contents of BS EN ISO 9445-2 include:
Scope
Normative references
Terms and definitions
Information to be supplied by the purchaser
Type of delivery and delivery condition
Preferred thicknesses
Tolerances on thickness for cold-rolled wide strip and products obtained from cold-rolled wide strip
Tolerances on width for cold-rolled wide strip and products obtained from cold-rolled wide strip
Preferred coil inner diameters for cold-rolled wide strip and slit cold-rolled wide strip
Tolerances on length for plate/sheet cut from cold-rolled wide strip and for cut lengths obtained from slit cold-rolled wide strip
Tolerances on edge camber for cold-rolled wide strip and products obtained from coldrolled wide strip
Tolerances on squareness for plate/sheet obtained from cold-rolled wide strip and cut lengths obtained from slit cold-rolled wide strip
Tolerances on flatness for plate/sheet obtained from cold-rolled wide strip and cut lengths obtained from slit cold-rolled wide ...
Open preview (PDF)Continuously cold-rolled stainless steel. Tolerances on dimensions and form - Wide strip and plate/sheet