Fasteners. Calculation methods for bolt/nut assemblies. Nut design
Fasteners. Calculation methods for bolt/nut assemblies. Nut design
This site uses cookies and visit counters for operation and statistics. Privacy policy
1 Scope This document specifies calculation methods for nuts designed to be mated with bolts, screws and studs in accordance with ISO 898‑1 , for use in bolted joints under tensile loading and for tightening with tension and torsion taking into account the three possible failure modes: bolt breaking, bolt thread stripping and nut thread stripping (see Clause 5). The terms “bolt” and “nut” are used as the general terms in this document for externally threaded fasteners (i.e. bolts, screws and studs) and internally threaded fasteners (i.e. tapped holes), respectively. This document is primarily applicable to steel hexagon nuts:
with ISO metric thread (coarse pitch and fine pitch, see ISO 68‑1 ); with diameter/pitch combinations according to ISO 261 and ISO 262 ; with thread tolerances according to
Standards mentioned in the description
