Motorcycles. Brakes and brake systems. Tests and measurement methods
Motorcycles. Brakes and brake systems. Tests and measurement methods
This site uses cookies and visit counters for operation and statistics. Privacy policy
BS ISO 8710:2010 Motorcycles. Brakes and brake systems. Tests and measurement methods BS ISO 8710 specifies tests and measurement methods for service brake systems and, where applicable, associated parking brake systems of two-wheeled motorcycles, motorcycles with sidecar and tricycles which are intended for use on public roads, in order to establish uniform worldwide test procedures for braking systems. BS ISO 8710 does not cover motorcycles which:
Have a maximum speed of less than 25 km/h Are equipped for disabled riders.
BS ISO 8710 sets out the following types of tests:
Dyamic tests Dy stop test (single brake control actuated) Dy stop test (all service brake controls actuated) Hgh speed test Wt brake test Hat fade test Parking brake system test Failure tests Partial failure test (for split service brake systems) Power-assisted brake system failure test.
The test methods (application, condition of the motorcycle, test procedure and parameters, measurement of performances) for all the tests defined in this International Standard are equivalent to the corresponding test methods prescribed by UNECE Global Technical Regulation No. 3. Content of BS ISO 8710: Foreword 1 Scope 2 Normative references 3 Terms and definitions 3.1 Vehicle categories 3.2 Brake system and components 3.3 Types of brake systems 3.4 Motorcycle loading 3.5 Test parameters 4 Test site conditions 4.1 Test surface 4.2 ...
Mentioned in the description and other BS standards
