Overview
IEC 61280-2-11:2006 is an international standard developed by the International Electrotechnical Commission (IEC). It outlines test procedures for fibre optic communication subsystems, focusing on digital systems. Specifically, this part details how to determine the averaged Q-factor using amplitude histogram evaluation for optical signal quality monitoring.
The standard addresses the need for accurate, non-intrusive signal quality monitoring in optical transport networks (OTN). It defines the averaged Q-factor and provides a practical procedure for its measurement using key amplitude histogram parameters, such as standard deviation and average level. This method supports performance monitoring in various locations throughout optical networks, especially where electrical termination isn't practical.
Key Topics
- Averaged Q-factor Definition: Establishes the concept and formula of the averaged Q-factor as a critical measurement for evaluating optical signal quality.
- Measurement Procedure: Outlines a stepwise process for measuring the averaged Q-factor using amplitude histograms, including apparatus setup, equipment connections, and threshold level definitions.
- Apparatus Requirements: Specifies necessary equipment such as:
- Optical bandpass filter
- Receiver
- Clock oscillator
- Electrical pulse generator
- Sampling module
- Signal processing circuit
- Performance Monitoring: Describes parameters relevant to the monitoring system and methods suitable for in-service and out-of-service testing.
- Data Analysis: Explains the use of amplitude histogram parameters, like standard deviation and average levels, for reliable quality assessment.
Applications
IEC 61280-2-11:2006 has wide applicability in modern fibre optic communication networks. Key applications include:
- Signal Quality Monitoring:
- Enables continuous, non-intrusive monitoring of signal integrity in optical transport networks.
- Supports detection of signal degradation due to noise (SNR degradation) and waveform distortion (e.g., chromatic dispersion).
- Network Operations & Maintenance:
- Facilitates service level agreements, fault isolation, and troubleshooting in real-time.
- Assists network operators in maintaining high service quality and reliability.
- Performance Monitoring in WDM Systems:
- Used at various monitoring points including optical line repeaters, regenerators, and optical switching nodes-especially valuable where electrical terminations are not feasible.
- Cost-Effective Testing:
- Provides an alternative to bit error rate (BER) testing, especially when low BER makes direct measurement time-consuming or impractical.
- Supports asynchronous sampling, which is compatible with a range of bit rates (including up to 160 Gbit/s) and signal formats (NRZ, RZ), making it adaptable for wavelength division multiplexed (WDM) systems.
Related Standards
For comprehensive coverage of fibre optic communication subsystem testing, consider these related IEC standards:
- IEC 61280-1 Series: General test procedures for fibre optic communication subsystems.
- IEC 61280-2 Series: Procedures for digital systems, including measurement of parameters such as jitter, noise, and chromatic dispersion.
- IEC 61280-4 Series: Test procedures for cable plant and fibre optic links.
- IEC 60793 and IEC 60794 Series: Specifications for optical fibre and cable products, respectively.
Conclusion
By following IEC 61280-2-11:2006, organizations and network operators can implement internationally recognized procedures for averaged Q-factor measurement. This supports accurate and efficient optical signal quality monitoring, contributing to robust performance and streamlined maintenance of fibre optic communication systems. The use of amplitude histogram techniques, as specified in this standard, provides a practical and scalable solution for monitoring signal integrity in today’s high-speed, high-capacity optical networks.
Open preview (PDF)Fibre optic communication subsystem test procedures - Part 2-11: Digital systems - Averaged Q-factor determination using amplitude histogram evaluation for optical signal quality monitoring
