Overview
IEC 61300-3-46:2011 is an international standard published by the International Electrotechnical Commission (IEC). It defines the basic test and measurement procedures specifically for the measurement of bore diameter for guide pins in MT ferrules, which are critical components in fibre optic interconnecting devices and passive components. This part of the IEC 61300 series targets MT ferrules made of thermoplastic and thermoset materials, aligning with specifications detailed in IEC 61754-5.
Ensuring precise bore diameter measurement is essential for maintaining the mechanical integrity and optical performance of fibre optic connectors, especially in high-density applications where MT ferrules are widely utilized.
Key Topics
- Scope of Measurement: The standard addresses the diameter measurement of guide pin bores within MT ferrules, which are key elements for fiber alignment in multi-fiber connectors.
- Pin Specifications: Utilizes traceable, calibrated gauge pins made from tungsten carbide steel with diameters ranging approximately from 0.69895 mm to 0.70005 mm in 100 nm increments. Specifications demand high cylindricity (100 nm or better) and surface finish (0.2 µm).
- Test Conditions: Measurements are conducted under controlled environmental conditions-temperature between 21.0 ºC and 25.0 ºC, with relative humidity at 50% ± 10%. The assembly mass for the test is standardized as 100 g ± 5 g.
- Measurement Procedure:
- Precondition parts for at least 24 hours as per test environment.
- Insert calibrated gauge pins into the MT ferrule bore from the recommended rear entry to minimize damage.
- Gradually apply the calibrated mass to pull the pin through the bore.
- Identify the effective bore diameter as the largest pin size that freely passes through under the test mass.
- Post-Test Examination: Following measurement, visually inspect ferrules for any damage-such as scratches, chipping, or breakage-as described in IEC 61300-3-1.
- Documentation Requirements: Specify test conditions, pin sizes used, and final bore diameter size for traceability and quality verification.
Applications
IEC 61300-3-46:2011 is invaluable for:
- Fibre Optic Connector Manufacturers: Ensuring components meet strict mechanical alignment tolerances to guarantee effective fibre coupling and low optical loss.
- Quality Control and Testing Laboratories: Offering a standardized method for accurate bore diameter measurement consistent with global quality standards.
- Telecommunications and Data Center Providers: Validating connector components to maintain high performance in high-speed optical networks.
- Equipment Calibration Facilities: Maintaining and calibrating precision gauge pins and measurement assemblies for reliable testing.
- Research and Development Teams: Facilitating the design evaluation of MT ferrules and associated interconnection components for improved performance.
Overall, the standard supports consistency, reliability, and interoperability in fibre optic interconnection systems.
Related Standards
- IEC 61754-5: Defines interface dimensions and requirements for the MT connector family, providing foundational specifications for MT ferrules.
- IEC 61300-3-1: Establishes procedures for visual examination and measurements, including inspection criteria post bore diameter testing.
- General IEC 61300 Series: Covers fundamental test and measurement procedures for fibre optic interconnecting devices and passive components, ensuring comprehensive testing frameworks.
For more on fibre optic connector standards and testing methodologies, visit the IEC Webstore or consult the IEC Electropedia for terminology.
Open preview (PDF)Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 3-46: Measurement - Bore diameter for guide pin in MT ferrules
