IEC 62841-3-17:2026 PDF

IEC 62841-3-17:2026 applies to transportable type 1 table masonry saws and type 2 table masonry saws that are equipped with one or more diamond cutting wheels with peripheral gaps, if any, not exceeding 10 mm and having no positive rake angle, having a diameter not exceeding 600 mm and used for cutting tile, bricks, stone, concrete block or other similar material. This document also applies to transportable type 4 masonry saws intended only for use with continuous rim diamond cutting wheels having a diameter not exceeding 260 mm and used for cutting tile, bricks, stone, concrete block or other similar material. This document does not apply to tools equipped with bonded abrasive wheels. This document does not apply to transportable cut-off machines. NOTE 101 Transportable cut-off machines are covered by IEC 62841-3-10. This document does not apply to type-3 cutting off machines in accordance with EN 12418:2021. This document is to be used in conjunction with IEC 62841-1:2014 and IEC 62841‑1:2014/AMD1:2025. This document supplements or modifies the corresponding clauses in IEC 62841-1:2014, so as to convert it into the IEC Standard: Particular requirements for transportable table masonry saws. NOTE The attention of National Committees is drawn to the fact that equipment manufacturers and testing organizations can need a transitional period following publication of a new, amended or revised IEC publication in which to make products in accordance with the new requirements and to equip themselves for conducting new or revised tests. It is the recommendation of the committee that the content of this publication be adopted for implementation nationally not earlier than 36 months from the date of publication.