Overview
ISO 2456:1986 specifies the requirements and test methods for water used as a solvent in physical tests of surface active agents (surfactants). This International Standard ensures the water used in such tests is of high purity and free from contaminants that could affect the accuracy of surfactant characterization. It details the parameters and limits for water quality, including residue after evaporation, electrical conductivity, oxidizable matter, absorbance at 254 nm, reactive silica content, and surface tension. Test methods are included in an annex, facilitating compliance verification.
This standard is critical for laboratories and industries involved in surfactant testing, providing a standardized water specification to support reliable and reproducible physical test results.
Key Topics
-
Residue after Evaporation:
Maximum 1.0 mg/kg measured after heating the water sample at 110 °C. This test checks for non-volatile impurities that may interfere with surfactant tests.
-
Electrical Conductivity:
Limited to 1 μS/cm at 25 °C to ensure minimal ionic contaminants, crucial for tests where ionic strength affects surfactant behavior.
-
Oxidizable Matter (Oxygen Content):
Maximum allowable 0.08 mg/l to limit organic and inorganic impurities that can interfere with oxidation-sensitive analytical methods.
-
Absorbance at 254 nm:
Should not exceed 0.01 absorbance units (using a 1 cm cell), indicating low levels of organic chromophores that might affect UV-based detection methods.
-
Reactive Silica Content:
Limited to 0.02 mg/l, preventing silica contamination which could alter surface tension or foaming measurements.
-
Surface Tension:
Between 71 and 72.8 mN/m at 20 °C, ensuring the water itself does not influence surface tension measurements in surfactant analysis.
-
Preparation and Storage:
Water must be prepared by double distillation under nitrogen atmosphere to avoid contamination; storage in inert, airtight containers is recommended only for short periods (up to one week), maintaining quality integrity.
-
Test Methods:
Detailed in the annex, including procedures for residue measurement, conductivity assessment, oxidizable matter quantification, UV absorbance measurement, silica content, and surface tension determination.
Applications
ISO 2456:1986 is applied primarily in:
-
Physical Testing of Surfactants:
Ensures solvent water quality for tests like surface tension determination, foaming power evaluation, and other physical property measurements critical in surfactant development and quality control.
-
Industrial Laboratories:
Provides a basis for preparing water used in the manufacturing and testing of detergents, emulsifiers, and other surface active products.
-
Research and Development:
Enables reproducibility in experimental assessments of surfactant properties by standardizing the solvent medium.
-
Quality Assurance:
Helps maintain consistency in test results by controlling impurities that may otherwise skew surfactant characterization.
Related Standards
-
ISO 3696 – Water for Laboratory Use:
Provides specifications for different grades of water intended for analytical purposes, including considerations for purity levels beyond surfactant testing.
-
ISO 304 – Surface Active Agents – Surface Tension Measurement:
Details the method for measuring surface tension, complementing ISO 2456 by standardizing key surfactant property analysis.
-
ISO 653 – Thermometers for Laboratory Use:
Ensures accurate temperature measurements during conductivity testing, critical for precise water property assessment.
Keywords: ISO 2456, surface active agents, surfactants, water specification, solvent water quality, test methods, residue after evaporation, electrical conductivity, oxidizable matter, UV absorbance, reactive silica, surface tension, water for laboratory use, physical testing of surfactants, water purity standards.
Open preview (PDF)Surface active agents — Water used as a solvent for tests — Specification and test methods