Overview
ISO 5599-2:2001 specifies standardized mounting interface surfaces for five-port, four-way pneumatic directional control valves with an optional electrical connector. Intended for valves up to a maximum rated pressure of 1.6 MPa (16 bar), the standard defines dimensional features, port and actuation identification, electrical connector mating geometry and basic electrical/contact requirements to promote interchangeability between valve manufacturers.
Key topics and technical requirements
- Dimensional requirements and tolerances for interface features and mounting surfaces across sizes 1E–6E, including orifice areas (examples: 79, 143, 269, 438, 652, 924 mm²).
- Surface condition: specified surface roughness Ra = 1.6 µm and flatness 0.1 mm over 100 mm for the mounting area.
- Port and orifice identification: principal flow ports numbered 1–5 and actuation orifices 12 and 14 (port 14 preferred for single-source external solenoid pilot supply). Defined actuation results and monostable valve stable position rules.
- Electrical connector specification (optional): connector must be removable, rated 300 V AC/DC, with contact arrangement of four live contacts plus one earth. Earth contact must make first and break last and is 1.5 mm longer than other contacts. Pins: 2.03–2.18 mm diameter; connector contact assignments and orientation (contacts 1 & 4 parallel to valve port slots; 1 & 3 for single solenoid; 2 & 4 for second solenoid; contact 5 earth). Wire cross-section guidance: 0.75–2.5 mm².
- Mounting interface drawings and tolerances: figures and tabulated dimensions for precise base/valve mating and connector envelope/engagement depths.
- Note: ISO 5599-2 addresses interface geometry and identification - it is not applicable to valve functional characteristics.
Applications
- Ensures mechanical and electrical interchangeability of five-port directional control valves in:
- Industrial automation and pneumatic actuators
- Machine tool and assembly-line OEM equipment
- Modular valve manifolds and quick-change pneumatic modules
- Maintenance and spare-part sourcing where cross-vendor compatibility is required
Who should use this standard
- Pneumatic valve manufacturers and designers
- Machine builders and system integrators
- Control-panel and manifold block designers
- Maintenance engineers specifying replacement valves or retrofit modules
Related standards
Recommended identification statement for documentation:
“Mounting interface dimensions conform to ISO 5599-2:2001, Pneumatic fluid power - Five-port directional control valves - Part 2: Mounting interface surfaces with optional electrical connector.”
Keywords: ISO 5599-2:2001, pneumatic fluid power, five-port directional control valves, mounting interface surfaces, electrical connector, port identification, dimensional tolerances, valve interchangeability.
Open preview (PDF)Pneumatic fluid power — Five-port directional control valves — Part 2: Mounting interface surfaces with optional electrical connector