Overview
ISO 7509:2015 specifies a laboratory method for determining the time-to-failure of glass-reinforced thermosetting plastics (GRP) pipes under sustained internal hydrostatic pressure at a defined temperature. The method applies when the external environment is air or water and is intended to generate data for long‑term pressure resistance of GRP piping systems. Typical outputs are time-to-failure results used to assess material performance, quality control, and design validation.
Key Topics and Requirements
- Scope and principle: Measures failure time for GRP pipes subjected to a constant internal hydrostatic pressure at a specified temperature; results vary with end‑loading conditions and external environment.
- Failure modes defined:
- Bursting - rupture with immediate loss of liquid and pressure drop.
- Leaking - visible liquid loss or continuous pressure drop.
- Weeping - slow passage of liquid detectable visually or electronically.
- Apparatus and accuracy:
- Dimensional measurements accurate to ±1.0 %.
- Pressure measuring device accurate to ±1.0 % of test pressure.
- Optional strain gauges accurate to ±2 %.
- Optional electrical resistance detection capable of sensing ≤ 3 MΩ between test liquid and an external conductive layer.
- Specimen preparation and conditioning: Full-length pipe section with smooth, perpendicular ends; condition at test temperature for 24 h prior to testing.
- Test procedure highlights:
- Fill specimen (water or test liquid), avoid air entrapment.
- Raise pressure to target within 5 min and maintain until failure.
- Record test duration with an accuracy of ±2 % (or ±24 h for long tests).
- Interruptions under 100 h may be allowed and must be recorded and deducted.
- Detection and reporting: Visual, pressure-loss, or electronic detection per the standard. The standard requires documented test reports including specimen ID, dimensions, environment, pressure, state of stress (end thrust), strain data (if measured), and time‑to‑failure.
Applications and Who Uses It
ISO 7509:2015 is used by:
- GRP pipe manufacturers for product development and quality control.
- Independent testing laboratories performing long‑term pressure tests.
- Design and materials engineers validating service life and safety margins.
- Certification bodies and standards committees assessing compliance.
Practical uses include material selection, verifying design pressure ratings, producing long‑term resistance data for life‑prediction (used with regression analysis), and supporting type approval and product certification.
Related Standards
- ISO 10928 - methods for regression analysis and establishing long‑term time‑to‑failure relationships (commonly used with ISO 7509 data).
- ISO 3126 - dimensional measurement procedures for plastics piping components.
Keywords: ISO 7509:2015, GRP pipes, glass‑reinforced thermosetting plastics, time‑to‑failure, hydrostatic pressure test, sustained internal pressure, pressure testing, failure detection.
Open preview (PDF)Plastics piping systems — Glass-reinforced thermosetting plastics (GRP) pipes — Determination of time to failure under sustained internal pressure