Overview
ISO 7632:1985 specifies performance test methods and requirements for elastomeric seals used in hydraulic disc brake cylinders intended for use with a petroleum‑based hydraulic brake fluid (service temperature up to 120 °C). The standard applies to solid‑section seals (square, rectangular and O‑ring types) mounted either stationary in the cylinder bore or on the movable piston. It defines required test apparatus, specimen preparation, test procedures and pass/fail criteria to ensure reliable sealing performance across temperature, chemical and mechanical stresses.
Key topics and technical requirements
- Scope and seal types: Solid section seals - square, rectangular and O‑ring - for disc brake pistons and bores; service temperature range −40 to +120 °C.
- Test fluid: Use the ISO reference petroleum‑base brake fluid (ISO 7309).
- Marking: Each seal must bear a green identification mark indicating suitability for petroleum‑base fluid (ink or tinted elastomer).
- Physical and chemical tests:
- Resistance to fluid at elevated temperature (120 ±2 °C, immersion 70 h): limits on volume change (0 to +15 %) and hardness change (typically within −7 to +8 IRHD after fluid exposure); precipitation (sediment) not to exceed 0.3 % by volume.
- Accelerated heat (dry air) ageing per ISO 188: allowable hardness change and no blistering/cracking.
- Hardness measured by IRHD per ISO 48; volume per ISO 1817.
- Mechanical/stability tests:
- Ambient, high‑temperature and high‑cycle stroking tests simulating piston movement (including 70 h at 120 °C, up to 500 000 cycles where specified).
- Leakage tests: high‑pressure (0.7 MPa for 5 min) and low‑pressure static tests (≈10 kPa for 24 h) after conditioning.
- Low‑temperature leakage at −40 °C with piston position cycling to simulate lining wear.
- Cycling humidity storage / corrosion test: 12‑day humidity/temperature cycle (95 % RH) to detect corrosion, adhesion or deterioration.
- Apparatus and specimen prep: ovens, test jars, centrifuge and stroking fixtures; specimens cleaned with hexane (brief contact) before testing.
Applications and users
ISO 7632 is used by:
- Brake component manufacturers and elastomer formulators for design verification and quality control.
- Automotive OEMs and suppliers specifying seal performance for disc brake systems.
- Independent test laboratories and certification bodies performing compliance/validation testing.
- Design and reliability engineers assessing seal compatibility with petroleum‑based brake fluids.
Benefits: ensures material compatibility, prevents leakage/failure across temperature extremes, and supports safety and durability of hydraulic disc brakes.
Related standards
- ISO 7309 - Reference petroleum base hydraulic brake fluid
- ISO 48 - Vulcanized rubbers - Hardness (IRHD)
- ISO 1817 - Determination of effect of liquids on vulcanized rubber
- ISO 188 - Accelerated ageing / heat‑resistance tests
- ISO 7631 - Elastomeric cups and seals for hydraulic braking systems
Keywords: elastomeric seals, hydraulic disc brake cylinders, petroleum‑based brake fluid, ISO 7632, O‑ring seals, IRHD hardness, leakage test, high temperature stroking, seal performance testing.
Open preview (PDF)Road vehicles — Elastomeric seals for hydraulic disc brake cylinders using a petroleum base hydraulic brake fluid (service temperature 120 degrees C max.)