Overview
ISO 7879:1997 - "Diesel engines - Cradle-mounted in-line fuel injection pumps - Mounting dimensions" is an international standard that defines the mounting dimensions and tolerances for cradle‑mounted in-line fuel injection pumps used on compression‑ignition (diesel) engines. Published as the third edition in 1997 and prepared by ISO/TC 22/SC 7, the standard provides dimensional tables and figures (Types 1–3) with values in millimetres to ensure mechanical compatibility and interchangeability of pump units.
Key topics and requirements
- Dimensional requirements for cradle-mounted in-line fuel injection pumps, presented in figures and tabulated values for various cylinder counts (4, 6, 8 and extended sizes in Type 3 such as 10 and 12).
- Tolerances and nominal values specified in millimetres to control fit and alignment between pump cradle and engine mounting.
- Multiple pump types (Type 1, 2, 3) with corresponding mounting layouts and critical dimensions illustrated in figures 1–3.
- Manufacturer choice: dimensions and requirements not covered by the standard are explicitly left to the manufacturer’s discretion.
- Informative annex (Annex A) and bibliographic references to related ISO documents on pump tapers and mounting flanges.
Applications and practical value
- Ensures mechanical compatibility between cradle‑mounted in-line fuel injection pumps and engine cradles, reducing redesign and fitment issues.
- Guides design engineers and CAD modelers when creating engine mounting interfaces and assemblies.
- Supports pump manufacturers and OEMs in producing units that meet common mounting profiles for interchangeability and aftermarket replacement.
- Used by service technicians and repair shops to verify mounting dimensions when fitting replacement pumps or performing engine overhauls.
- Useful for quality control, procurement specifications, and supplier communication to ensure consistent mounting geometry across suppliers.
Who should use this standard
- Engine manufacturers and integrators (OEMs)
- Fuel injection pump designers and suppliers
- Aftermarket and replacement pump manufacturers
- Mechanical design and installation engineers
- Maintenance and repair facilities working on diesel engines
Related standards
Annex A (informative) cites related ISO standards that complement ISO 7879:
- ISO 6519 - Tapers for shaft ends and hubs
- ISO 7299 - End‑mounting flanges for fuel injection pumps
- ISO 7612 - Base‑mounted in‑line fuel injection pumps - Mounting dimensions
Keywords: ISO 7879, diesel engines, cradle-mounted in-line fuel injection pumps, mounting dimensions, pump mounting, engine compatibility, injection pump standards.
Open preview (PDF)Diesel engines — Cradle-mounted in-line fuel injection pumps — Mounting dimensions