Overview
ISO 8829-1:2009 - Aerospace - Test methods for polytetrafluoroethylene (PTFE) inner-tube hose assemblies - Part 1: Metallic (stainless steel) braid specifies standardized test methods for flexible PTFE inner tubes used with stainless-steel braided hoses and hose assemblies in aircraft fluid systems. The standard applies within the pressure and temperature ranges defined by pressure classes and temperature types in ISO 6771. ISO 8829-1:2009 is referenced when required by procurement or performance specifications and defines how to verify material and assembly performance where tests are not otherwise specified.
Key topics and requirements
ISO 8829-1:2009 focuses on test methods rather than prescriptive performance limits (performance requirements are provided in procurement or performance specifications). Major technical topics include:
-
Inner-tube material tests
- Density and relative density measurements (to control PTFE crystallinity) following ISO 7258 methods.
- Tensile testing procedures (specimen preparation, test speeds, machine calibration, measurement of tensile strength and elongation).
- Rolling (diametral flexing) to detect manufacturing flaws and subsequent proof pressure testing.
-
Electrical properties
- Electrical conductivity/resistivity test setup and procedure for inner tubes (preconditioning, salt-water electrode method).
-
Hose and hose-assembly tests
- Stress degradation, pneumatic effusion, volumetric expansion, leakage and proof-pressure tests.
- Burst pressure, impulse (dynamic) testing, flexure, fuel resistance, low-temperature flexure, pneumatic surge, vacuum and thermal shock tests.
- Fire resistance testing in accordance with ISO 2685 zones where applicable.
-
Test media and preparation
- Test fluids listed in Annex A are referenced for specific tests.
- Conditioning, cleaning, and humidity control procedures for reproducible results.
Practical applications and users
ISO 8829-1:2009 is used to ensure safety, reliability, and traceability of PTFE-lined stainless-steel braided hoses in aerospace fluid systems. Typical users include:
- Aerospace component manufacturers and hose assemblers validating product conformance
- Test laboratories performing acceptance, qualification, or failure analysis
- Procurement and quality engineers writing specifications and acceptance criteria
- Design and certification teams verifying hydraulic, fuel, pneumatic, or fluid-transfer systems
- MRO (maintenance, repair and overhaul) organizations assessing in-service hose integrity
Applying ISO 8829-1 helps reduce variability in test methods, supports supplier acceptance, and assists compliance with aircraft system safety and reliability requirements.
Related standards
- ISO 6771 - Pressure classes and temperature types for aerospace hoses
- ISO 8829-2 - PTFE inner-tube hose assemblies - Non‑metallic braid
- ISO 7258 - PTFE tubing density and relative density methods
- ISO 6772, ISO 6773 - Impulse and thermal shock test methods for aerospace fluid systems
- ISO 2685 - Fire resistance procedures for airborne equipment
Keywords: ISO 8829-1:2009, PTFE inner-tube hose assemblies, stainless steel braid, aerospace test methods, hose testing, fluid systems, pressure classes, tensile test, proof pressure, electrical conductivity.
Open preview (PDF)Aerospace — Test methods for polytetrafluoroethylene (PTFE) inner-tube hose assemblies — Part 1: Metallic (stainless steel) braid