Overview
ISO 9974-2:1996 - "Connections for general use and fluid power - Ports and stud ends with ISO 261 threads with elastomeric or metal-to-metal sealing - Part 2: Stud ends with elastomeric sealing (type E)" specifies the dimensions, designation, performance requirements and test procedures for light‑duty (L series) and heavy‑duty (S series) stud ends with ISO 261 metric threads using elastomeric (type E) seals. The standard covers dimensional drawings, materials for test samples, burst and impulse test methods, cyclic endurance requirements and the recommended test data form (Annex A).
Key topics and technical requirements
- Scope and use: Stud ends for ports in general‑purpose and fluid‑power systems (tube, pipe and hose fittings) with ISO 261 threads.
- Series and pressure ratings: L series (light duty) and S series (heavy duty). S series may be used up to 63 MPa (630 bar) in some sizes; L series up to 25 MPa (250 bar). Actual allowable working pressure depends on size, material, design and application.
- Dimensions and designation: Thread sizes and stud‑end dimensions follow ISO 261 thread forms and the tables/figures in the standard. Example designation: Stud end ISO 9974-2 - M12 x 1.5 S; seal: Elastomeric seal ISO 9974-2 - M12 x 1.5.
- Materials for testing: Test blocks hardened to 50–55 HRC; stud ends made of low carbon steel and plated; test seals (for qualification) specified as nitrile (NBR) with hardness (90 ± 5) IRHD.
- Test procedures:
- Burst pressure test with controlled pressure‑rise rate (max 138 MPa/min).
- Cyclic endurance (impulse) test: typically six samples, 1 000 000 cycles at designated impulse pressure.
- Requirement that burst/working pressure ratio meets or exceeds 4:1 for qualification.
- Test torques for qualification are given (examples in standard); assembly tightening torque for production should follow manufacturer guidance.
- Reporting: A standardized test data form (Annex A) records results, materials, torques and failures.
Applications and who uses it
- Useful for hydraulic and pneumatic system designers, fittings and connector manufacturers, test laboratories, quality engineers and procurement/specification teams.
- Typical applications: hydraulic manifolds, connectors on hose and tube fittings, fluid‑power components where reliable elastomeric sealing on ISO 261 threaded stud ends is required.
Related standards
- ISO 9974-1 (threaded ports), ISO 9974-3 (stud ends with metal‑to‑metal sealing), ISO 261 (metric screw threads), ISO 8434‑1/4 (tube connections), ISO 6149 (note on new hydraulic design practice). These provide complementary dimensional, thread and connector guidance.
Keywords: ISO 9974-2:1996, stud ends, elastomeric sealing, ISO 261 threads, fluid power, ports, burst test, cyclic endurance, nitrile (NBR) seal, S series, L series.
Open preview (PDF)Connections for general use and fluid power — Ports and stud ends with ISO 261 threads with elastomeric or metal-to-metal sealing — Part 2: Stud ends with elastomeric sealing (type E)