Overview
ISO 9980:2012 - "Belt drives - Grooved pulleys for V‑belts (system based on effective width) - Geometrical inspection of grooves" - defines standardized methods for geometrical inspection of pulley grooves used with classical or narrow V‑belts (single or joined). The standard sets out a four‑step inspection sequence to verify groove regularity and conformity with effective‑width based dimensions, helping manufacturers and quality teams ensure reliable belt drive performance.
Key topics and requirements
- Inspection principle: Complete inspection is carried out in four successive checks -
- groove profile, 2) groove spacing, 3) effective diameter, 4) run‑out tolerances.
- Groove profile: Specifications include effective width, groove angle, groove depth, sidewall bevel depth and (for joined belts) groove land height. Limit gauges are used to check minimum/maximum angle, effective width and depth; different gauge ends and angles are required per groove section.
- Groove spacing: For multiple‑groove pulleys the nominal spacing (e) and tolerances are specified. Inspection uses a groove spacing locator and sets of interchangeable inspection balls; measured dimension minus ball diameter gives groove spacing.
- Effective diameter: Nominal effective diameter and allowable variation or tolerances between grooves are specified. Measurement uses two cylindrical balls or rods; the measured separation between tangent planes minus a corrective term (2hs) yields the effective diameter.
- Run‑out tolerances: Radial and axial circular run‑out tolerances for specified measurement positions are defined; inspections are performed during one revolution about the bore axis. Datum references and measurement distances are specified.
- Inspection tools and markers: Limit gauges, balls/rods, Vernier calipers and groove locators are described for repeatable production control.
Practical applications
- Ensures dimensional conformity of grooved pulleys used in industrial transmissions and automotive belt drives.
- Supports production control, incoming‑inspection, tooling set‑up and acceptance testing.
- Reduces belt wear, vibration and misalignment by verifying groove geometry, spacing and run‑out.
- Useful for manufacturers producing grooved pulleys, test laboratories, maintenance teams and purchasing/specification engineers.
Who should use this standard
- Pulley and belt manufacturers
- Quality and inspection engineers
- Design engineers specifying pulley geometry for power transmission
- Maintenance and reliability engineers performing component acceptance
- Standards committees and testing laboratories
Related standards
Keywords: ISO 9980:2012, grooved pulleys, V‑belts, effective width, geometrical inspection, groove profile, groove spacing, effective diameter, run‑out tolerances, limit gauge, pulley inspection.
Open preview (PDF)Belt drives — Grooved pulleys for V-belts (system based on effective width) — Geometrical inspection of grooves