Overview
SIST ISO 4405:2023 - Hydraulic fluid power - Fluid contamination - Determination of particulate contamination by the gravimetric method - defines a standardized gravimetric test to quantify particulate contamination in hydraulic fluids. The method measures the mass of suspended solids captured on a filter membrane after passing a defined fluid volume under vacuum. SIST ISO 4405:2023 updates the original 1991 edition, streamlines calibration and equipment requirements, and specifies the reliable single‑membrane procedure for mineral‑oil based hydraulic fluids.
Key technical topics and requirements
- Scope: Gravimetric determination of dirt content in mineral‑oil hydraulic fluids (categories HH, HL, HM, HV, HG per ISO 11158); suitable for concentrations ≥ 3 mg/L.
- Principle: Filter a known volume of fluid through a single membrane; the mass increase of the membrane (after solvent rinsing, drying and conditioning) equals particulate contamination (mg/L).
- Filter membrane: 47 mm diameter, 0.8 µm pore size (cellulose acetate / mixed ester examples cited).
- Solvent: Petrol 40/65 (or 40/60/petroleum ether) filtered through 0.2 µm; hexane‑free recommended for safety; Annex A covers alternative solvents if qualified.
- Equipment & conditions: vacuum filtration unit, analytical balance (±0.02 mg), non‑ventilated drying oven (≈80 °C used for conditioning), exsiccator, vacuum pump, and controlled room conditions (20–30 °C, 30–65% RH).
- Procedures emphasized: membrane conditioning and weighing, blank test (blank ≤ 0.1 mg), sample handling and representative sampling (ISO 4021 referenced), rinsing and drying steps to ensure repeatability.
- Quality notes: Double‑membrane method removed due to lower reliability; test repeatability and documentation procedures are specified.
Practical applications and who uses this standard
SIST ISO 4405:2023 is used to ensure hydraulic system reliability and to control contamination that affects performance, wear and longevity. Typical users include:
- Test laboratories performing hydraulic oil cleanliness analysis
- OEMs and hydraulic system designers integrating contamination control criteria
- Maintenance and reliability engineers for condition‑based maintenance programs
- Oil suppliers and quality control departments verifying product cleanliness
- Research institutions studying particulate contamination effects on hydraulic components
Practical uses include routine oil monitoring, failure investigation, filter performance evaluation, and comparative contamination reporting.
Related standards
- ISO 4021 - Extraction of fluid samples from operating systems (sampling guidance used by ISO 4405)
- ISO 11158 - Classification/specification of hydraulic oils (HH, HL, HM, HV, HG)
- ISO 5598 - Fluid power vocabulary (terms and definitions)
Keywords: SIST ISO 4405:2023, gravimetric method, particulate contamination, hydraulic fluid power, hydraulic oil cleanliness, filter membrane, contamination analysis.
