Overview
ISO 304:1985 specifies a standardized laboratory method to determine the surface tension of liquids and solutions of surface active agents (surfactants) by drawing up liquid films. The method measures the maximum vertical force required to detach a plate, stirrup or ring from a liquid surface (or to draw up a film on a plate edge) and converts that force to surface tension in millinewtons per metre (mN/m). The standard covers apparatus, preparation of test portions, cleaning, calibration and measurement procedure, plus expression of results and precision.
Key topics and technical requirements
- Test principle: measure the peak force when a film linking the measuring unit and the liquid surface breaks; translate force to surface tension using defined geometrical factors.
- Measuring units: rectangular platinum plate, platinum–iridium stirrup, or platinum–iridium ring - each requires specific handling and correction factors (ring correction factor f).
- Apparatus: tensiometer with a vertical micrometer platform (0.1 mm resolution), dynamometer accurate to at least 0.1 mN/m, and vibration/draft shielding.
- Calibration: calibrate tensiometer with known-surface-tension liquids or riders of known mass; include wetting sheath calibration for plates and buoyancy corrections for stirrups.
- Sample preparation & cleaning: use double‑distilled water for solutions, rigorous cleaning of measuring cup and platinum elements (sulfo‑chromic/sulfuric acid rinses when needed), avoid volatile solvents in the test room.
- Temperature control: maintain sample temperature within ±0.5 °C; avoid testing near critical solubility points (Krafft, cloud points).
- Precision: for pure liquids that fully wet platinum, achievable precision is about 0.1 mN/m; repeat measurements over time are recommended for solutions whose surface tension changes with ageing.
Applications
- Quality control of surfactants, detergents and formulations where surface tension is a critical parameter.
- R&D and formulation development in chemical, cosmetic, pharmaceutical and coatings industries.
- Calibration and validation of tensiometers and comparative method testing between plate, ring and stirrup techniques.
- Academic studies of interfacial phenomena and fundamental surface science.
Who should use ISO 304:1985
- Laboratory managers and technicians performing surface tension testing.
- QA/QC teams in surfactant and formulation manufacturing.
- Instrument manufacturers and service labs validating tensiometer performance.
- Researchers requiring a reproducible mechanical method for surface tension measurement.
Related standards
- ISO 862 - Surface active agents: Vocabulary (definitions used).
- ISO 2456 - Surface active agents: Water used as a solvent for tests (water quality requirements).
Keywords: ISO 304:1985, surface tension, surface active agents, surfactants, tensiometer, ring method, plate method, stirrup method, mN/m.
Open preview (PDF)Surface active agents — Determination of surface tension by drawing up liquid films
