Overview
ISO 9538:2017 specifies a planar flexure test procedure for reconnectable and permanent hydraulic tubing joints and fittings used in aerospace applications. The standard applies to fittings with high‑strength hydraulic tubes made of corrosion‑resisting steel, titanium and aluminium for commercial and military aircraft. It defines test equipment, specimen preparation, instrumentation and a vibration‑based procedure to assess flexure fatigue performance under combined internal pressure and bending loads.
Key topics and requirements
- Test device and setup
- Vibrator, manifold (to receive at least six specimens) and hydraulic supply unit with pressure monitoring and shutdown capability.
- Vibrator capable of up to 300 Hz.
- Specimens
- Include the test fitting (e.g., straight union), test tube and end fitting to seal the tube.
- Instrumentation
- Strain gauges required on each specimen; gauge placement: approximately 4 mm from attachment point for tube sizes to DN 16, 8 mm for DN 20 and above.
- Angle gauges and stroboscope recommended for deflection control.
- Frequency and dynamic tuning
- Recommended test frequency ≈ 100 Hz.
- Specimen natural frequency should be 110–120 Hz; test frequency set about 10–20% below natural frequency to avoid resonance.
- Tube length is adjusted (with gauges and pressure applied) to achieve required natural frequency.
- Stress determination and calibration
- Combined stress is the sum of mean axial (from internal pressure) and bending stress; bending stress is determined by strain gauges and calibrated by applying a static load to reproduce the required moment before dynamic testing.
- Acceptance criteria
- Test specimens shall withstand 10^7 cycles with no leakages or failures.
Applications
- Qualification and fatigue validation of aerospace hydraulic tube fittings.
- Laboratory fatigue testing to demonstrate flexure resistance of fittings on steel, titanium and aluminium tubing.
- Alternative to rotary flexure methods where planar vibration testing is preferred or required.
Who uses this standard
- Aerospace component manufacturers and tube‑fitting suppliers
- Environmental/test laboratories and fatigue test facilities
- Design and qualification engineers, quality assurance and certification authorities
- Maintenance and overhaul organizations validating repair fittings
Related standards
- ISO 7257 - Aircraft - Hydraulic tubing joints and fittings - Rotary flexure test (alternative method)
- ISO 7169 - Separable tube fittings for aerospace fluid systems (procurement/qualification context)
Keywords: ISO 9538:2017, planar flexure test, hydraulic tubing joints, aerospace, tube fittings, flexure fatigue stress, strain gauges, vibration frequency, natural frequency, test specimens.
